闪迪超速缓存固态硬盘 用不了！求解决！！急

百度搜的 你可以拿有道词典翻译一下 是不是驱动要重新安装一下
Installing SanDisk ReadyCache SSD
How do I install the SanDisk ReadyCache SSD?
Installing the SanDisk ReadyCache SSD is easy. There is NO need to replace or clone your current hard drive.

Before installing the SanDisk ReadyCache SSD, please review components or cables required to install it.

STEP 1 - Install the SanDisk ReadyCache SSD on a desktop computer

NOTE: The SanDisk ReadyCache SSD is designed to work in conjunction with your existing system hard disk drive. Therefore, it MUST be installed as a non-bootable secondary drive on your desktop computer. You must NOT partition the SanDisk ReadyCache Drive. The ExpressCache software will partition and format the drive in a proprietary file system.

1. Turn the computer off.
2. Disconnect the computer from any electrical sources to avoid potential damage to the motherboard and yourself.
3. Remove the side access panel (please refer to your computer's owner manual if you do not know how to do this).
4. Locate a spare bay underneath or near your main the hard disk drive bay.
5. Insert the SanDisk ReadyCache SSD into the spare bay with the data and power socket facing the rear face of the computer case.
6. Locate a thin SATA power connector from the computer's power supply and insert it into the power socket on the drive.
7. Insert one end of the SATA cable into the drive's SATA data socket.
8. Insert the opposite end of the SATA cable to a free SATA port located on the motherboard.
9. Close the computer case.
10. Plug the computer back in.

STEP 2 - Install the ExpressCache software
You must download the ExpressCache software
1. Download the ExpressCache software ExpressCacheSetup.exe
2. Double-click on ExpressCacheSetup.exe.
3. Select your language from the drop-down menu, and then click OK.

4. The ExpressCache software Setup Wizard starts. Click Next on the first screen.

5. Read the License Agreement, click to select the check box to confirm your acceptance of the terms of the License Agreement, and then click Next.

6. Click Change if you want the ExpressCache software to be installed to a folder other than the one specified. If you want to create a shortcut on your desktop, click to select the Create a shortcut on my desktop check box. Click Next.

7. Click Install to confirm.

8. Click Finish after the installation is completed.

9. Your system needs to be restarted. Click Yes to restart now or No if you plan to restart it later.

10. The following message will appear after the initial computer reboot. By default, caching is disabled. To enable caching, you need to activate the ExpressCache software by clicking on Activate.

Troubleshooting
If the SanDisk ReadyCache SSD is NOT detected, a "ExpressCache did not find any ReadyCache devices on the machine. Install ReadyCache device first and then start ExpressCache install again. Setup will now exit." message will appear.
1. Make sure the power and SATA cables connected correctly.
2. Make sure the SATA port on the motherboard BIOS is enabled.
3. If it is still NOT detected, try another SATA port or cables.